Page 11 of 11
Posted: 14 Apr 2016, 15:35
by lolpes
7bit wrote: 
As soon as I have the time, I will write the software to generate those mount plates.
BTW: I would not complain if anybody would make mount plates for these PCBs all on his own.
Paging @LeandreN
Also @7bit did @Ziptyze ever managed to contact you about possibility to make cases for the Hypermicro? Talked to him a couple weeks ago and he seemed very excited about the idea.
Posted: 30 May 2016, 03:25
by Jacked
7bit wrote: ¡¡¡BUMP!!!
Not sure if you're the guy I contacted on ebay but I need stabilizers shipped to the UK in this sizing 6.25 2.25 2.25 2.75 2.0. Never installed stabilizers but this will be for a plate mounted board. I know with switches and a plate mounted board it don't matter because you can just clip the switch clips. But I am not sure if you can do that with stabilizers
Posted: 08 Jul 2016, 05:17
by s.trooper
Bump. Still waiting on this.
Posted: 29 Apr 2017, 22:04
by Madhias
I found a PCB here in my keyboard box! I also have I think all needed parts here, but which layout should I choose?
Posted: 29 Apr 2017, 22:23
by lolpes
Check ir the pcb is working, some have traces missing or don't register some keys
Posted: 30 Apr 2017, 20:00
by Madhias
What would be the best way to test with only soldering the teensy and the diodes (without switches)? I guess with the multimeter and continuity mode?
Posted: 22 Jul 2017, 18:16
by Putin
am i too late to buy a pcb and plate