[WTB] capacitive board(s?) for prototyping
Posted: 23 May 2019, 02:51
Looking for a relatively cheap(ish) board for prototyping a capacitive controller.
Does not have to look nice at all, just have a reasonable number of keys (say >30%) in place so that I have something to test with.
Keyboards where the capacitive matrix is separate from the controller electronics, so that they can be easily disconnected without maiming/killing the keyboard are preferred.
Models for which capacitive controllers are sought for are strongly preferred (e.g. want to work on this for community use, and not just for a once-off project, so models that are widely used are preferred).
Does not have to look nice at all, just have a reasonable number of keys (say >30%) in place so that I have something to test with.
Keyboards where the capacitive matrix is separate from the controller electronics, so that they can be easily disconnected without maiming/killing the keyboard are preferred.
Models for which capacitive controllers are sought for are strongly preferred (e.g. want to work on this for community use, and not just for a once-off project, so models that are widely used are preferred).